Publicité
Les langues disponibles
Les langues disponibles
is attached to the door and cabinet. After the panel is removed
from the door, drill the mounting holes from the front, to the
recommended diameter of the handle manufacturer. Counter
bore the back-side of the panel so the screw heads do not inter-
fere with the surface of the door.
Step 6: Drill panel mounting holes
Re-clamp the panel to the door per step 5 and drill the screw
pilot holes for attaching the overlay panel to the door. Select
the size of the hole from Table B. Be careful not to drill the pilot
holes through the overlay panel, (1/2" (12.7mm) deep for 3/4"
(19mm) and 5/8" (15.7mm) panels ).
Material Type
Hardwood
Softwood
NOTE
If your refrigerator has a door lock proceed to Step 7. If your
refrigerator does not have a door lock proceed to Step 9.
Step 7: Mark and drill lock hole.
Locate and mark with a pencil the location of the lock hole on
the overlay panel, this is the hole in the top corner of the handle
side of the door. Remove the clamp and remove the overlay
panel from the door. On the backside of the panel where you
marked the lock location drill a 13/16" (20.5mm) diameter coun-
ter bore 7/16" (11.0mm) deep into the overlay panel. Drill a 15/32"
(12.0mm) diameter hole through the overlay panel centered on
the counter bore being careful not to splinter the wood on the
face side of the panel. (See Figure 10).
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
#8 Wood Screw
1/8" (3.2mm) Diameter. Pilot Hole
7/64 (2.8mm) Diameter. Pilot Hole
Table B
1.234" (31.3mm)
.991" (25.2mm)
Figure 8
Figure 9
18
Top Hinge
Adapter
Hole in hinge
adapter
Door
Overlay Panel
Hole in bottom
hinge adapter
Publicité
