Publicité
Les langues disponibles
Les langues disponibles
objects may be hidden from view by
surrounding snow. If the snow blower hits
an obstruction or picks up a foreign object
during use, stop the snow blower, remove
the battery, remove the obstruction, and
inspect the unit for damage. Repair or
replace any damaged part before restarting
and operating the unit.
2.
Keep children, pets, and bystanders away
from the area of operation. Be aware that
the normal noise of the machine when
turned on may make it difficult for you to
hear approaching people.
3.
When moving the snow blower, use the
wheels on one side as the pivot point.
Slightly tilt the snow blower on this pivot
point to move it forward or backward.
4.
Start your clearing path outward, throwing
snow in a back and forth motion. To clear
in the opposite direction, pivot the snow
blower on its wheels. Make sure to overlap
clearing paths.
5.
Note the wind direction. If possible, move in
the same direction as the wind so that the
snow is not thrown against the wind (and
thus back into your face and on the just
cleared path).
6.
Do not push the snow blower with
excessive force. You should push the
machine gently and evenly in accordance
with the unit's throw rate.
7.
Do not apply additional man-made load
to the motor since this may cause motor
damage.
8.
Some parts of the snow blower may freeze
under extreme temperature conditions. Do
not attempt to operate the snow blower
with frozen parts. If the parts freeze while
the snow blower is in use, stop the snow
blower, remove the battery, and inspect for
frozen parts. Free all parts before restarting
or operating the snow blower. Never force
controls that have frozen.
9.
When working on pebbles, gravel, or
unpaved surfaces, avoid throwing loose
surface material along with the snow by
pushing down on the handle to raise the
scraper at the base of the unit above the
pebbles or gravel.
10.
The LED light will be activated immediately
when the machine is started.
CHANGING THROW
DIRECTION + THROW
HEIGHT + THROW SPEED
EN - 10
WARNING:
Never direct the snow discharge chute at
the operator, at bystanders, at vehicles, or at
nearby windows. The discharged snow and
foreign objects accidentally picked up and
thrown by the snow blower can cause serious
damage and personal injury. Always orient the
discharge chute in the opposite direction from
where the operator, bystanders, surrounding
vehicles, or windows are located.
1.
The discharge chute can be controlled 180
degrees by rotating the handle of chute
control rod.
2.
The chute deflector on the top of the
discharge chute controls the height of the
snow stream. Squeeze the trigger to raise
or lower the deflector to the desired height
of snow you wish to throw.
3.
The speed control lever controls the snow
removal and throwing speed of the snow
blower. Pull or push the lever to make the
snow blower work at the desired spped.
Fig. 10
Fig. 11
WWW.SENIXTOOLS.COM
Publicité
