Publicité
E04
E09
Welding
E10
machine
E12
E13
E14
E15
E16
Switch
E20
E21
E22
E23
Accessory
E30
Communication
E40
E41
MA200TS Multi-process welder
Over-heating (4th thermal relay).
Over-heating (Program in default).
Phase loss.
No gas.
Under voltage.
Over voltage.
Over current.
Wire feeder over load.
Button fault on operating panel when
switch on the machine.
Other faults on operating panel when
switch on the machine.
Torch fault when switch on the
machine.
Torch fault during normal working
process.
Cutting torch disconnection.
Connection problem between wire
feeder and power source.
Communication error.
18 |
P a g e
protection) always on.
Yellow lamp (thermal
protection) always on.
Yellow lamp (thermal
protection) always on.
Yellow lamp (thermal
protection) always on.
Red lamp always on.
Yellow lamp (thermal
protection) always on.
Yellow lamp (thermal
protection) always on.
Yellow lamp (thermal
protection) always on.
Yellow lamp (thermal
protection) always on.
Yellow lamp (thermal
protection) always on.
Yellow lamp (thermal
protection) always on.
Yellow lamp (thermal
protection) always on.
Red lamp blink.
Publicité
