Publicité
Les langues disponibles
Les langues disponibles
I. ASSEMBLY INSTRUCTIONS
ASSEMBLY OF THE BASE
Position the counterweight (12) under the plastic
base (11), place the base trim (10) and insert the
lower tube (9) into the center hole. Secure it by
adding the washer (13) and tighten with the elbow
screw (14).
FAN ASSEMBLY
The height of the fan can be adjusted by loosening
the height adjustment screw (8). Raise or lower the
main extension tube (7) carefully and firmly tighten
the set screw.
Position the blower housing (6A) on the top of the
main extension tube (7) and push it down. Lock the
connection with the clamping screw (6B)
Loosen the nut (4) of the motor (6). Position the rear grille (5) on the motor, making
the 3 mounting studs coincide and hold it firmly (Make sure the grill handle is at the
top) Tighten the nut (4) on the grill so that it block the grill on the engine.
Fit the fan blades (3) on the shaft. Make sure that the locking pin (across the axle)
fits into the notches on the back of the blade. Secure it firmly with the reverse step
nut (2). (Screw in the opposite direction of the clockwise)
At this time, the blades should be able to turn freely without touching the clamping
nut of the rear grille.
Unscrew the screw on the rear grille (5). Place the front grille on the back grille,
matching the hole in the front grille (1) with the hole in the back grille. Secure the
grids with the clips and use a screwdriver to tighten the locking screw (1L).
23
Publicité
