eXact PipeCut P400 Mode D'emploi page 14

Operation, Maintenance
Loosen the locking screw (Fig.P/1) with the M5 allen
key on the handle of the Exact P400. There is an
adjustment wheel on the right hand side of the
steering device (Fig. P/2). Turn the wheel with your
finger either clockwise or anti clockwise. The direction
depends on the direction of the misalignment. This
adjustment turns the entire motor unit in relation to
the steering unit. There is also an arrow and a dial
on the steering unit. (Fig. P/2) These will help to
gauge the extent of the adjustment. Adjust the motor
unit to the desired direction to correct the sawing
error. The extent of the adjustment depends on the
extent of the error, pipe diameter as well as the
strength and material of the pipe wall. Tighten the
locking screw (Fig. P/1) after the adjustment.
Installing and changing the
saw blade
WARNING: To reduce the risk of injury,
turn unit off and disconnect it from power
source before installing and removing
accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Remove the power plug from the socket. Check that
the motor unit is locked in the upper position.
Remove the blade guard cover (Fig. Q/1) by opening
the screw (Fig. Q/2). Press the spindle-lock button
(Fig. A/12) and simultaneously rotate the blade by
hand until the spindle-lock button drops a further
distance of about 4 mm. Now the rotation of the
blade is prevented. Use the blade key to open the
blade attachment bolt. Remove the securing bolt
(Fig. Q/3), the washer (Fig.Q/4), the blade flange
(Fig. Q/5), and the blade (Fig. Q/6).
Before installing a new blade, check that both blade
flange discs are clean. Place a new or sharpened
blade on the lower blade flange (Fig. Q/7), so that
the marked side of the blade is facing outwards and
the arrows on the blade are facing in the same
direction as the rotation direction markings on the
inside of the blade case. Ensure that the new blade
goes right to the bottom in the lower blade flange.
Put the blade flange, the washer, and the securing
bolt back in place. Press the spindle lock button and
tighten the blade securing bolt. Put the blade guard
cover back in place and tighten the screw.
Fig. N
Fig. O
Fig. P
Fig. Q
14
e n g l i s h