Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
It is most important that the base of the steering
device does not touch the pipe but rather that the
wheel pairs support the saw (Fig. E3). Finally lock
the adjustment with the safety screw (Fig. E1) so
that the adjustments do not alter during the sawing.
Pull the lever on the moving bladeguard to an
towards you. (Fig. F and A/5) Place the Exact P400
horizontally on top of the pipe so that a suitable
setting mark for the blade that is in the machine is
positioned at the cutting point (Fig F). Hold the pipe
in place and ensure that the Exact P400 moves
freely in the direction the pipe is fed. To ensure
safety the Exact P400 leads should be to the left
and front of the pipe. The Exact P400 is now ready
for use.
Piercing the pipe wall
Strive to keep the P400 in a horizontal position on
top of the pipe during the entire sawing process.
Take a firm hold of the operating handle with your
right hand, start the motor by releasing the locking
lever on the power switch (Fig. G/1) and push the
power switch all the way down(Fig. G/2). Before
starting to saw wait until the blade reaches full
speed. Pierce the pipe wall by pressing the operating
handle down slowly until the blade has cut through
the pipe wall (at this stage the pipe must not rotate)
and the motor unit has locked into sawing position.
When the UNLOCK button is locked, i.e. the yellow
mark disappears (Fig. H), the Exact P400 is locked
and you can safely start sawing around the pipe.
When using a
CutBevel
performed especially calmly.
Sawing around the pipe
Start sawing by rotating the pipe with your left
hand towards yourself (Fig. I) and keep the Exact
P400 stable and in a horizontal position in relation
to the pipe (Fig. J). Continue sawing by rotating
the pipe calmly and at the most even speed
possible towards yourself until the pipe is cut off.
If you use a
CutBevel
approximately 5 cm after the pipe has been cut
off. This will ensure an even bevel around the
entire pipe. If you bevel an additional round you
will get even better result.
The saw can also be steered manually if the
blade does not coincide with the initial cut. When
you see the starting point of the cut, turn the saw
at a gentle angle towards the initial cut until the
pipe is cut off (Fig. L)
s u o m i
blade piercing must be
blade continue sawing
Fig. F
Fig. G
Fig. H
Fig. I
12
e n g l i s h
Publicité
Table des Matières
