Tripp-Lite SmartPro SMX1500XLRT2U Manuel Du Propriétaire page 15

Masquer les pouces Voir aussi pour SmartPro SMX1500XLRT2U:

Les langues disponibles

Basic Operation

Tap the

button repeatedly to advance to Sensitivity display, as shown on the previous page.

Press the

button to advance through the options. The last option displayed, before navigating

away from this menu option, will be the selected setting.

External Battery Setting Control (Select Models)

This control menu option only appears when the UPS is configured using the External Battery Utility

software and is reporting "YES" in the External Battery LCD Control Screen. The only available LCD

interface configuration option is to change the setting from "YES" to "NO" external batteries.

Note: See the Optional Installation section for information on configuring the UPS for external battery operation

using the External Battery Utility software.

Tap the

button repeatedly to advance to the External Battery display, as shown below.

To set the UPS to "NO" External Battery, press and hold the

Note: The Battery Runtime calculation is based on this setting. The runtime and charger rate will automatically

recalculate once the external battery setting is configured for "NO" external batteries.

Factory Mode Reset

The LCD settings can be restored to Factory Mode by holding the MODE and ENTER/MUTE buttons

simultaneously for 5 seconds while in any display mode.

CAUTION: This action cannot be undone. The user must reconfigure the UPS for external

batteries if the UPS's setup includes external batteries.

20-10-127- 933184.indb 15

continued

YES

button for 3.5 seconds.

10/16/2020 11:04:35 AM