Publicité
Les langues disponibles
Les langues disponibles
a.
Select a suitable location that is convenient for mounting, is accessible for wiring
and has ample room for air circulation and cooling.
b.
Use the amplifier as a template to mark the mounting holes, remove the amplifier and drill 4 holes. Then mount the amplifier
with the mounting screws.
Chose a mounting position where all eclectic wires are protected from being damaged by sharp edges, heat or other conditions. +12Volt
DC electrical connections must be fused on the battery side. Make sure your radio and all other devices will be turned off while connection
your system.
This amplifier has now internal fuse. Therefore it is absolutely necessary to connect an ANL- fuseholder) with 350 A fuse. The cable length
between amplifier and fuseholder must not be longer than max 20 cm / 7.9". Please see the connection diagram on the following side for
correct wiring.
The amplifier automatically turns on a few seconds after you turn on your radio.
Note: Your amplifier temporarily shuts down if it gets too hot, then restarts automatically once it cools
(At about 80° / 176° F).
1.
LEVEL (Min/Max): Turn fully counter- clockwise to MIN position
2.
Turn the auto sound system's volume control to about two-third of its full range.
3.
Adjust LEVEL to a comfortable listening level.
Mounting your amplifier
Warning
Turning on the amplifier
Adjusting the audio level
Publicité
