YATO YT-82320 Manuel D'instructions page 11

PRODUCT OVERVIEW
The steamer allows for quick and effi cient soaking of wall wallpapers with the use of steam. This makes it easier to remove them
from walls with a spatula. The large tank and the long hose connecting the tank and the steamer allow effi cient and ergonomic
operation. The correct, reliable, and safe operation of the appliance depends on its proper use, so:
Read and keep the entire manual before the fi rst use of the product.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual. Use of the product for purposes other than those for which it was intended shall cause the loss of the
user's rights to the guarantee and under warranty.
ACCESSORIES
The product is delivered complete but requires assembly before operation. The product includes: a steamer, a water tank, a hose
connecting the steamer with the tank and a detachable power cord.
SPECIFICATION
Parameter
Cat. No.
Rated voltage
Rated frequency
Rated power
Water tank capacity
Maximum steam temperature
Ingress protection rating
Protection class
Weight
SAFETY INSTRUCTIONS
Caution! Read all of the following instructions. Failure to do so may result in electric shock,
fi re, or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment containing fl ammable liquids, gases, or
vapours.
Before starting the product for the fi rst time, make sure that the product, its accessories, and
the power cord have not been damaged. If any damage is discovered, it is not allowed to
start working with the product. Any damaged components, including the power cord, must be
replaced at an authorized facility. It is not allowed to repair the product on your own.
Always use personal protective equipment such as heat-resistant gloves, work clothes with
long sleeves and legs, and work shoes with an anti-slip sole. Protective goggles should also
be worn.
The product is intended for indoor use only. Do not expose the product to any precipitation or
moisture. If water and moisture enters the product, the risk of an electric shock is signifi cantly
increased. Do not immerse the product in water or any other liquid.
The room in which the product will be used should be well lit and ventilated. If the operator
feels unwell due to steam build-up and an increase in temperature, operation should be
O R I G I N A L
EN
Units
[V~]
[Hz]
[W]
[l]
[ O C]
[kg]
I N S T R U C T I O N S
Value
YT-82320
230 - 240
50
2000
4.5
100
IPX4
I
1
11