CASO DESIGN Beer Master Mode D'emploi page 58

DE
3.1 Universal 5 L keg
EN
ES
SV
FR
IT
NL
1. Follow the instructions given on the beer keg. Make sure that the keg has rested for
long enough to avoid foam coming out of the tap. Use a pre-cooled keg.
2.
Place the pointed end of the spike (A) on the sealing ring (B) located in the centre of
the keg's top. You may need to remove the closure or replace the seal (see the "Beer
keg seals" section).
3.
Hold the spike vertically and quickly push it into the keg (C). You will hear a noise
which signals that the spike has clicked into place on the keg's top.
4.
Release the locking mechanism on the cover to open the beer dispensing unit and
place the correctly assembled keg in the cooling chamber (Fig. 4).
5.
Attach the beer hose connector (D) and the CO₂ connection hose (E) (Fig. 5).
PLEASE NOTE
f
Make sure that all the connectors are correctly attached to
the beer riser tap and that they are not damaged. Check
that the tap is in the "Off" position. The CO₂ pressure regula-
tor knob must be set to "Off" or "-".
58 CASO Beer Master
(A)
(B)
(C)
Fig.4
(E)
(D)
Fig.5