CASO DESIGN Beer Master Mode D'emploi page 11

PLEASE NOTE
f Defective components must always be replaced with original repla-
cement parts. Only such parts will guarantee that the safety require-
ments are fulfilled.
f Use the appliance only as described in the user's guide to avoid possi-
ble injury from misuse.
f Do not use the appliance:
• if the appliance itself or parts are damaged,
• if the power cord or plug is damaged,
• if the appliance has been dropped.
f Always unwind the power cord completely before use. When doing so,
ensure the power cord is not damaged by sharp edges or hot objects.
f Do not make any modifications to the appliance or the power cord.
Only have repairs carried out by a specialist workshop, as appliances
that have not been repaired properly endanger the user. Please also
observe the enclosed warranty conditions.
f Only use the appliance with original accessories.
f The dispenser should not be used to cool other liquids and beverages.
f Do not expose this device to rain or other environmental conditions.
f Do not remove the keg from the dispenser until it is completely empty.
f Do not remove the CO₂ pressure cartridge until it is empty.
f To avoid unintended start-up of the dispenser, make sure that the on/
off switch is turned to "Off" before you connect to it to a power source.
f Leaving the door open for a longer period of time may result in a
significant temperature increase in the dispenser chamber.
f Before you insert a keg, make sure that it is not damaged and that its
use-by date has not expired.
f Pre-cool the beer keg before you use it. Do not put the keg in a freezer
to do this.
f Do not shake the keg before you use it.
f Do not expose the keg to direct sunlight. The keg must be stored as
per the instructions on its label.
CASO Beer Master 11