Publicité
Les langues disponibles
Les langues disponibles
4.
Spread the floating cable over the pool, making
sure there are no kinks or coils in the cable .
NOTE: For optimal patterning and reduced tangling, the
floating cable should enter the water near the
middle of the pool length. Only place enough
cable in the water to reach the farthest point in
the pool (see Figure 13).
cleaner
cleaner
Max
Floating Cable
Length
Figure 13. Set Up for Optimal Patterning
4.3
Starting the Cleaner
The first time you use the cleaner, the cleaning surface
setting is Floor and Walls
After the first time, the default is the last setting used.
Select Cleaning Surface:
• Use
to change cleaning surface setting.
Begin Cleaning:
•
After selecting the cleaning surface,
press
to begin operation.
•
At the beginning of the cycle, the cleaner
remains in place for a few seconds to initialize
NOTE: Periodically the cleaner will pause for up to 20
4.4
Not
Recommended
The cleaner has the ability to clean the pool walls up to
the waterline. How much the cleaner needs to grip to the
caddy /
wall depends upon the pool surface.
control unit
Grip Intensity Indicator:
Surface Control System (SCS) settings are as follows
Recommended
entry point
for different pool surface types:
Check Wall Climbing Setting:
.
NOTE: Wall climbing is programmed in a randomized
the microcontroller after the pump starts.
seconds throughout the cleaning cycle. The cleaner
is calibrating its position in the pool during this
process. This is normal operation and the cleaner will
resume movement immediately after calibration with
no user action required. The pause does not affect
the overall cleaning cycle.
Wall Climbing (Surface Control
System™)
1 Pebble Surface (ROUGH)
2 Concrete
3 Vinyl / Fiberglass
4 Tile (SMOOTH)
•
Start the cleaner and watch as the cleaner
climbs each wall. If grip setting is correct, the
cleaner will easily climb the wall and clean up
to the waterline. The default setting is
pattern. Cleaner may climb wall and not reach
waterline until third or fourth attempt in order
to thoroughly clean wall surface below the
waterline first.
•
Adjust the wall climbing setting as necessary
using the following guidelines:
if cleaner is climbing the wall slowly
Increase:
and stays below the waterline.
if cleaner is climbing the wall too
Decrease:
quickly and sucking air at the waterline.
Page 9
1 Pebble Surf
2 Concrete
3 Vinyl / Fiber
4 Tile (SMOOT
Publicité
