SNOWJOE sunjoe SPX2790-MAX Manuel De L'opérateur page 11

m
WARNING!
Do not make changes to the nozzle while
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.
Working with Detergents
When cleaning with the pressure washer, some cleaning tasks
can be solved with water alone, but for most tasks cleaning with
detergent allows for more effective dirt removal.
m
WARNING!
Use only detergents specifically designed for
use with pressure washers, such as Sun Joe
WASH (SPX-HDC1G), Sun Joe
(SPX-FCS1G), or Sun Joe
®
(SPX-APC1G). DO NOT USE household detergents, acids,
alkaline solutions, bleaches, solvents, flammable material,
or industrial grade solutions. These could damage the
pressure washer. Many detergents may require mixing prior
to use. Prepare the cleaning solution as instructed on the
solution bottle.
1. Gently pull the foam cannon bottle out of its storage
position (Fig. 17).
Fig. 17
2. Remove the cap. Fill the bottle or mix as recommended by
detergent instructions (Fig. 18), and replace it back on the
unit. Secure the cap back into place.
Fig. 18
Foam cannon bottle
® HOUSE + DECK
® SNOW FOAM AUTO WASH
HEAVY DUTY CLEANER
Foam
cannon
bottle
Detergent
for pressure
washer
3. Recap the detergent bottle, and attach it to the stainless
steel lance by snapping it onto the Quick-Connect collar
until it clicks into place (Fig. 19).
Fig. 19
Foam cannon
wings
4. Turn on the pressure washer. Pull the trigger to operate the
unit. The liquid detergent will automatically mix with water
and be discharged through the nozzle.
NOTE: The spray angle can be adjusted from 0° to 45° by
rotating the foam cannon nozzle. The foam volume can be
adjusted by rotating the adjustable cap, as indicated below
(Fig. 20).
Fig. 20
Decrease soap
volume
Fan spray
Pencil jet
m
WARNING!
Do not adjust the foam cannon while the
trigger is squeezed. Failure to do so could result in damage.
m
CAUTION!
Always test the detergent in an inconspicuous
area before use.
5. Apply detergent from the bottom to the top of the dry
surface to be cleaned.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
6. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on the
surface.
m
CAUTION!
Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
11
Stainless steel lance
Foam cannon
Increase soap
volume
Adjustable cap
Adjustable
nozzle