SNOWJOE sunjoe SPX2790-MAX Manuel De L'opérateur page 10

NOTE: The GFCI may need to be reset when first plugged into
the electric outlet. Press the "Reset" button until the power
light indicator on the GFCI illuminates when plugged in.
5. Turn the water supply tap on completely.
6. Make sure the safety lock is down and in its original
position, then press the trigger for a few seconds until water
flow is steady. This will allow air to escape and discharge
any residual pressure in the hose (Fig. 13).
Fig. 13
7. Turn the ON/OFF switch to the ON (I) position to start the
pressure washer (Fig. 14).
Fig. 14
ON/OFF switch
8. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
Using Nozzles
Before beginning any cleaning task, determine the best nozzle
for the job. Each of the nozzles has a different spray pattern.
The nozzle patterns are 40° (for gentle cleaning), 15° (for tough
jobs), and 0° (for spot cleaning or hard-to-reach areas).
m
safety lock on the trigger handle.
m
subject to misuse. The jet must not be directed at persons, pets,
live electrical equipment, or the appliance itself.
This electric pressure washer is equipped with three (3) Quick-
Connect nozzles that easily snap onto the Quick-Connect collar
of the stainless steel lance.
Safety lock
To connect a nozzle to the spray wand:
Slot
Trigger
To disconnect a nozzle from the spray wand once the cleaning
job is complete:
10
CAUTION!
NEVER change nozzles without locking the
WARNING!
High-pressure jets can be dangerous if
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle by pushing up
on the safety lock until it clicks into the slot (Fig. 15).
Fig. 15
3. Snap the desired nozzle onto the Quick-Connect collar until
it clicks into place (Fig. 16).
Stainless steel
lance
Quick-Connect collar
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle by pushing up
on the safety lock until it clicks into the slot (Fig. 15).
3. Remove the nozzle by placing your hand over the nozzle
while pulling back on the Quick-Connect collar.
Slot
Safety lock
Fig. 16
"Click"
Nozzle