Publicité
Les langues disponibles
Les langues disponibles
Installation
NOTE: Do not completely tighten bolts until indicated
in assembly step.
1
Removing all the bolts and washers
from the table top and table legs
Place the table top (A) upside down on a non-abrasive work
■
surface and attach the table leg (B) to the table top (A) by using
two
1/4 * 5/8 in.
bolts (AA) through two washers, through table
leg (B) and into table top (A). Repeat procedure for the other
three legs.
B
A
2
Attaching the metal center ring to
the table legs
Attach the metal center ring (C) to the table legs (B) by using
■
two
1/4 * 5/8 in.
bolts (AA) through two washers, through metal
center ring (C) and into table leg (B). Repeat procedure for the
other three legs.
C
B
AA
AA
Care and Maintenance
Though its powder-coated nish is rust-resistant, steel is prone to rust over time with exposure to the elements. In case of rust or scratches,
lightly sand the affected area and apply touch-up paint. To maintain the nish periodically apply wax with a soft cloth.
Wash frames with a mild solution of soap and water; rinse thoroughly. Do not use bleach or solvents.
Always use an umbrella base to secure umbrella. Do not store anything on glass tabletop. Ensure the "o" ring is in place
in the umbrella hole in the glass top before inserting umbrella. Make sure umbrella is in the closedposition when not in
use and during high winds. Use furniture covers or store indoors during cold or inclement weather.
AA
B
C
3
Tightening all the bolts
Turn table upright, then tighten all bolts (AA) in a diagonal pattern.
■
AA
Your table is now ready for use.
4
Publicité
