Publicité
Les langues disponibles
Les langues disponibles
8. CLEANING & MAINTENANCE
Allow the appliance to cool down completely before cleaning and
maintenance.
The surfaces and controls are susceptible to scratches and
abrasion. Please observe the following cleaning instructions.
8.1 Stainless steel
The stainless steel must be cleaned regularly (weekly)
to ensure a long service life. Stainless steel surfaces
can be cleaned with a proprietary nonabrasive
cleaning agent designed specifically for use on
stainless steel.
8.2 Control panel
The control panel can be cleaned with warm soapy
water. Make sure the cloth is clean and thoroughly
wrung out before cleaning the control panel.
Use a dry, soft cloth to remove excess moisture after
cleaning.
8.4 Aluminum grease filter
An oversaturated filter is a fire hazard. The aluminum grease filter
in the appliance removes solid particles from the kitchen vapors,
grease, dust, etc., therefore, preventing soiling of the rangehood.
Grease filter cleaning intervals
The grease filter should be cleaned regularly (at least
every 3-4 weeks) to avoid a build-up of grease
8.5 Removing the aluminum grease filter
When removing the grease filter do not tilt it down-
wards at an angle. This can damage the retaining
pins.
With the deflector plate pushed in, grip the front of
the deflector plate and hold the grease filter securely.
Whilst holding the grease filter, pull the deflector plate
out as shown.
Then pull the filter downwards to remove it.
Switch off the fan.
When handling a grease filter, be careful not to
drop it. This can result in damage to the filter
and the cooktop below. Make sure you hold the
filter securely at all times when handling it.
Observe all safety and warning information during operation
(see the "General Safety Instructions" section).
Before maintenance or cleaning, the rangehood should always
be disconnected from the power supply. Make sure that the
rangehood is switched off and the plug has been removed.
Exterior surfaces are prone to scratches and dents. Therefore,
please follow the cleaning instructions to achieve the best
possible result without damage.
8.3 Cleaning agents
Do not use stainless steel cleaning agents on the controls.
Use neutral cleaning agents and avoid using harsh cleaning
chemicals, strong household cleaners or products containing
abrasive cleaners as this will affect the appearance of the
appliance and may remove the printed symbols on the control
panel.
Cleaning the grease filter by hand
The reusable aluminum filter can be cleaned by hand.
Soak them in water together with a grease-dissolving
detergent for about 3 minutes and then brush them
gently with a soft brush. Do not apply too much
pressure to avoid damaging the filter. Allow the filter
to air dry afterwards, but do not place it directly in the
sun. Filters should always be washed separately from
crockery and kitchen utensils!
Remove the filter as shown in the image
below and reinsert the filter in reverse order.
1
3
12
2
Publicité
