BorMann PRO BDM6600 Mode D'emploi page 2

EN
SAFETY INSTRUCTIONS
Warning: Read the manual carefully before use. Failure to follow the warnings and instructions may result in product damage and/or
physical injury. Store the manual in a safe place for future reference.
• This is a class II laser product. Do not stare into the beam at any time when operating this product.
• Do not look directly into the beam with optical aids (e.g binoculars, telescopes).
• Do not remove any safety labels from the product.
• Do not allow children to use the product.
• Do not open the product.
• Do not modify the equipment in any way.
IMPORTANT INFORMATION
• When measuring, do not point the laser directly at the sun.
• Do not immerse the product in water.
• Do not clean the lens using alcohol or any other organic solvent.
• Do not wipe the lens with fingers or objects with rough surfaces.
• Do not power the equipment beyond the rated DC voltage.
TECHNICAL SPECIFICATIONS
Technical data
Model BDM6600
• 0.05-40 m (0.16-131 ft)
• 0.05-60 m (0.16-196 ft)
Measuring range
• 0.05-80 m (0.16-262 ft)
• 0.05-100 m (0.16-328 ft)
Accuracy ±2 mm (±0.079 inch)
Measuring units m, in, ft
Laser type Class II, 620-690 nm, <1 mW
Material ABS & PET
Leveling method Electronic angle
Power supply 2x 1.5V AAA batteries
Data store / Recall function 99 sets
Size & Weight 115*50*23 mm, 82 g
LCD SCREEN INDICATIONS
2
Fig. 1
WWW.NIKOLAOUTOOLS.COM M M
* The manufacturer reserves the right to make minor changes to product
design and technical specifications without prior notice unless these changes
significantly affect the performance and safety of the products. The parts
described / illustrated in the pages of the manual that you hold in your hands
may also concern other models of the manufacturer's product line with similar
features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity,
all repair, inspection or replacement work, including maintenance and special
adjustments, must only be carried out by technicians of the authorized service
department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the
product with non-provided equipment may cause malfunctions or even serious
injury or death. The manufacturer and the importer shall not be liable for
injuries and damages resulting from the use of non-conforming equipment.
• Laser indication.
• Measurement reference.
• Continuous measurement.
• Area / volume measurement.
• Pythagoras measurement.
• Error indication.
• Battery capacity indication.
• Max and min indication.
• Data storage.
• Unit indication.
• Angle indication.
• Current measurement.
• Calculation display.