BEA SC 55/2-SPEED Mode D'emploi page 31

Caution
When the battery pack is low or the drive requires too much torque, the
tool may stall at the bottom of the drive (before the clutch can disengage).
Continuous operation in this manner can cause over-heating and
permanent damage.
To remove the screw belt from the auto feed attachment
Reverse knob
Replaceable Non Slip Pad
1.To remove the belt, pull it
Press
1.The non slip pad is self
upwards through the top of
the nosepiece. When a screw
is out of position or if it jams,
pull the belt downwards while
pressing the reverse knob.
replaceable when
damaged.
31