Tool Operation - BEA SC 55/2-SPEED Mode D'emploi

Tool Operation

(b)
Main Switch
(a)
Change / set the speed
Forward/Reverse Rod
1 Reversing rod switch on the
indicated tool side. See fig. on
the left:
-Non-depressed rod switch means:
Clockwise (forward) bit rotation.
-Depressed rod switch means:
Counterclockwise (reverse) bit
rotation.
2. Whenever possible, keep the
tool at a 90° degree angle to
the work surface.
3. (a)
Pull the main switch to start the
motor.
(b)
Press the tool feed attachment
against the work surface, applying
constant pressure.
Do not remove the tool from the work
surface until the clutch disengages
and the bit stops rotating, signaling
the screw is all the way in. Then
return the tool from the work surface
so that the feed attachment can move
backwards.
Keep the main switch depressed
countinously to run the motor and
repeat the screwing cycle.
29