Vivanco FMH 6080 Mode D'emploi page 11

6. Trouble-shooting
Problem
No sound
Sound interference
Transmitter switches
itself off
If these suggested solutions do not lead to the desired result, please contact your dealer.
Please note:
This appliance is not authorised for any application other than those mentioned above. No liability is accepted for any problems
arising, damage caused, etc. if used otherwise. In addition, the connection leads (e.g. audio leads) used should not be longer
than 3 metres. Naturally, Vivanco gives its warranty (currently 6 months) for all appliances in accordance with legal warranty
stipulations.
7. Technical data
Transmission frequency:
Transmission channels:
Transmitting power, max:
Frequency range:
Signal-to-noise ratio:
Non-linear distortion factor: < 1.8%
Power supply:
Automatic transmission cut-out
Technical data subject to alteration.
260101
Solution
Make sure that the On/Off switch (B7) on the headphones is in the „ON" position.
Are the power-on lamps on the transmitter (A1) and the headphones (B10) constantly lit?
Check whether the AC adapter (C) is correctly connected and check the condition of the battery
packs. Details in sections 4 and 5.
Check whether the audio source is switched on and emitting a signal.
Have you connected the transmitter to the audio source?
If you are operating via an adjustable headphones socket on your audio source, make sure that it
is turned up high enough (e.g. to about the middle setting).
Use the frequency selection control (A3) to change to a different transmission frequency.
Activate the frequency search (B9) again.
Make sure that the interference is not being caused by your audio source.
In certain cases it may be necessary to alter the position of the transmitter horizontally and/or
vertically.
Check the power-on lamp (B10). See section 5.
Do not place the transmitter directly in front of a television set, but at a distance of approx. 1 m.
Increase the volume at the headphones socket or the phono output of your audio source.
If the audio signals are too weak the transmitter will otherwise switch off automatically.
See 4.1.3.
863 - 865 MHz
3
10 mW
20-20,000 Hz
> 45dB
Headphones: 2 AA batteries
Transmitter: AC adapter, 12 Volt / 100 mA
11