Publicité
Les langues disponibles
Les langues disponibles
1)
The meter will display current clock and line voltage, frequency, if plug in socket after
insert battery without any operation
2)
Press FUNC button once and release, the meter will display current clock and line
current, power factor
3)
Press FUNC button once again and release, the meter will display current clock and real
power, power factor
4)
Press FUNC button once again and release, the meter will display max. line power and
the appear time of max. line power, power factor. Press and hold FUNC button for 5
seconds will clear max. line power display during this state
5)
Press FUNC button once again and release, the meter will display current clock and
accumulative power factor
6)
Press FUNC button once again and release, the meter will display total on time and total
electrical charge
7)
Press FUNC button once again and release, the meter will display total on time of price 1
and total electrical charge of price 1
8)
Press FUNC button once again and release, the meter will display total on time of price 2
and total electric charge of price 2
9)
Press FUNC button once again and release, the meter will come back to display current
time and line voltage. Press and hold FUNC button for 5 seconds to clear accumulative
total electric quantity and total electric charge during display state of total electric charge
or total electric charge of price 1 or total electric charge of price 2
10) LCD display
will flash at the same time
Setting current clock:
1)
Press FUNC button until the CLOCK displays in LCD
2)
Press SET button once time, the WEEK DAY will flash at the same time, the clock
change to SET mode, you can set the current clock
3)
Press UP button to set the WEEK DAY
4)
Press SET button once time again and release, the HOUR will flash the WEEK DAY will
stop flashing and keep display
5)
Press UP button to set the HOUR
6)
Press SET button once time again and release, the MINUTE will flash, the HOUR will
stop flashing and keep display
7)
Press UP button to set the MINUTE
8)
Press SET button once time again and release, the time come back to CLOCK display
mode
9)
Press UP button during the CLOCK display state, change 12-24 hour mode. To reset
incorrect time, repeat all above steps. After finish setting, plug the meter into a regular
230/240V power outlet, plug in an appliance that you want to use and turn the mains
power on. Now the meter begins to measure the consumption of the appliance and
detect the equipment that uses too much electricity at once
Corrections EL-EPM02FHQ_A5.indd 3
when total electric quantity, total electric charge overflow, the OVER
3
2009.6.10 6:03:04 PM
Publicité
