Edesa EDW-6231 WH/A Manuel D'instructions page 69

Type 2
Underneath existing work top
(When fitting beneath a work top)
In most modern fitted kitchens there is only one
single work top under which cabinets and
electrical appliances are fitted. In this case remove
the work top of the dishwasher by unscrewing the
screws under the rear edge of the top (a).
Attention
After removing the work top, the screws must be screwed again under the rear edge
of the top (b).
Selecting the best location for the dishwasher
The installation position of the dishwasher should be near the existing inlet and drain
hose and power socket.
Illustrations of cabinet dimensions and installation position of the dishwasher.
1. Less than 5 mm between the top of dishwasher and cabinet and the outer door
aligned to cabinet.
2. If dishwasher is installed at the corner of the cabinet,
there should be some space when the door is opened.
NOTE:
Depending on where your electrical outlet is
you may need to cut a hole in the opposite
cabinet side.
EN
90 °
Electrical, drain Electrical, drain
820mm 820mm
and water supply and water supply
line connection line connection
580mm 580mm
Space between cabinet Space between cabinet
bottom and floor bottom and floor
for 60cm model
600 mm(
mm for 45cm model
450 (
21
90 °
80 80
100 100
)
)
Dishwasher
Door of
dishwasher
Minimum space
of 50mm
a
a
b
b
Cabinet