Publicité
3-3 AC/DC Voltage Measurement
1. Set the slide switch to the " V • " position.
2. Connect the black test lead to the "COM" terminal on the bottom of the meter and the red test lead to the
" V-•" terminal . You can now place the test probes on the conductors to make the measurement.
3. Press the AC/DC switch to select AC mode or DC mode.
3-4 Resistance Measurement
•
1. Set the slide switch to the "•
" position.
2. Connect the black test lead to the "COM" terminal and red lead to the " V- •" terminal.
3. Verify that the power to the circuit under test is off. Connect test leads to the circuit to make the measurement.
•
4. Press the • /
switch to select Resistance mode or Continuity mode.
•
5. In
mode, the internal sounder will operate if the resistance of the circuit under test is less than 50• .
F 23
Publicité
