Joycare SPIRITOSO JC-1207 Mode D'emploi page 17

JC-1207/1208/1209
GB
D) Pass the diagonal car seat belt through the upper guide at the back of the child seat.
Pull the car lap belt through the lower guide located on the base (FIG.14)
14
NOTES:
The car seat belt must be pulled tight, making sure that it is not twisted
For GROUP 0+, the car seat MUST be positioned to face in the rearwards direction.
The child seat should be reclined to position "4"
The airbag must be deactivated.
E) Once the child seat is attached to the car seat, loosen the harness by pulling on the straps while
pressing the harness adjuster button (FIG.15)
F) To place the child in the seat, undo the harness by pressing the harness release button on the
buckle (FIG.16)
16
15
G) Position the child correctly in the seat (FIG.17)
H) Reconnect the harness to the buckle until it clicks into place. (FIG.18)
I) Adjust the harness to the right tightness for the child by pressing on the harness adjuster button
and pulling on the adjustment strap.
J) Make sure that the child is properly secured, that the buckle is not pressing on the child's
stomach, that the harness is tight without causing discomfort and that the shoulder pads are at
the right height for the shoulders. (FIG.19)
17