Publicité
Les langues disponibles
Les langues disponibles
MOUNT THE DOCK (FIG. 4)
Wall-mount Holes
1. Make sure the two rubber blocks fit into the upper slots of back on the dock.
2. Mark the locations of the five wall-mount holes at the desired location on a wall.
3. Use five #8 or #10 screws with the length of at least 2.5" (63 mm) and washers
(not included) to securely mount the dock to the wall.
NOTICE:
Mounting surface should be at least 3/4'' (19 mm) thick to securely support
the dock.
4
Wall-mount Holes (5)
Mounting onto E-track Rail
(Fig. 5)
EGO E-track mounting kit AEK1000 (sold
separately) is required to mount the dock
onto an E-track rail.
1. Disconnect the dock from the hub
and remove the battery packs.
2. Remove the 2 rubber blocks shown
in Fig. 2.
3. Install the E-track clips (included in the kit) into the recessed areas (vacated by
the rubber blocks) as shown in Fig. 5.
4. Use the assembly tool (included in the kit) to secure each E-track clip to the dock
using M5 bolt and washer sets (included in the kit).
5. Insert two rubber bumpers (included in the kit) into the outer lower slots on the
back of the dock.
14
PGX
COMMERCIAL CHARGING 3-PORT DOCK — PGX3000D/PGX3000D-FC
™
Rubber Blocks (2)
5
E-track Clip(2)
Bolt and
washer set (2)
E-track Rail
Rubber
Bumper(2)
Publicité
