Makita ADCB200 Manuel D'instructions page 10

3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
PARTS DESCRIPTION
Battery holder (optional accessory)
► Fig.1
1 Battery holder for CXT
battery cartridge
5 Adapter cable
► Fig.2
1 Power cable
5 Extension cord
INSTALLATION
Installing or removing the battery
cartridge
CAUTION:
Always switch off the device
before installing or removing the battery
cartridge.
CAUTION:
Hold the battery holder and the
battery cartridge firmly when installing or remov-
ing the battery cartridge. Failure to hold the battery
holder and the battery cartridge firmly may cause
them to slip out of your hands and result in damage
to the battery holder and battery cartridge and/or a
personal injury.
► Fig.3: 1. Red indicator 2. Button 3. Battery cartridge
4. Battery holder (optional accessory)
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert the battery cartridge all the way until
it locks in place with a small click. If you can see the red
indicator on the upper side of the button, it is not locked
completely.
To remove the battery cartridge, slide it from the battery
holder while pressing the button on the front of the
cartridge.
CAUTION:
Always install the battery car-
tridge fully until the red indicator cannot be seen.
Otherwise the battery cartridge may accidentally
fall out of the battery holder, causing injury to you or
someone around you.
CAUTION:
Do not forcibly install the battery
cartridge. If the battery cartridge does not slide in
easily, it is not being inserted correctly.
2 Battery holder for LXT
battery cartridge
- -
2 Battery pocket
- -
10 ENGLISH
4. When not using the battery cartridge, remove
it from the tool or the charger.
5. Charge the battery cartridge if you do not use
it for a long period (more than six months).
3 CXT battery cartridge
(10.8 V - 12 V max)
- -
3 Power button
- -
Attaching the battery holder
Take the power cable out of the battery pocket and
connect the jack to the plug of the adapter cable.
► Fig.4: 1. Power cable 2. Jack 3. Adapter cable
Using the battery pocket
The battery holder (with battery cartridge) can be stored
in the battery pocket. Take the power cable out of the
battery pocket and connect the jack to the plug of the
adapter cable. After that, put the battery holder (with
battery cartridge) into the battery pocket and fasten the
zip fastener.
► Fig.5
CAUTION:
After storing the battery holder
(with battery cartridge) into the pocket, be sure to
fasten the fastener.
The belt hook on the battery holder can be detached by
removing the screws.
► Fig.6: 1. Screw 2. Belt hook
Using the extension cord
If you put the battery holder out of the battery pocket,
connect the extension cord between the jack of the
power cord and the plug of the adapter cable.
► Fig.7: 1. Extension cord 2. Power cable 3. Adapter
cable
NOTICE:
When using the extension cord, be
careful in handling the battery holder because the
battery holder may be dropped by accident.
4 LXT battery cartridge
(14.4 V / 18 V max)
- -
4 Heating element (inside)
- -