Publicité
Note:
Before beginning the installation, make sure all power is
off, shutting power off in breaker box to areas where downlights
are to be installed is recommended.
Required Tools (not included): Safety glasses and gloves.
1. Double check and measure the ceiling hole. Make sure it is the
correct size for outside rim of the luminaire to cover the hole while still
allowing the back of luminaire to sink in to the ceiling and springs to
hold fi rmly.
Remove existing retrofi t can if present or move it out of the way
since it will not be needed for installation.
If new hole is to be cut, use provided hole template. Place
template over the desired location. Trace the outer ring with a pen
or pencil (not included). Cut the opening with a saw (not included).
(Figure 1)
Figure 1 / Figura 1 / Schéma 1
2. Open the cover of the attached driver box. Push and remove one
of the knockouts on the side plate.
Locate power supply leads from driver box and connect to power
source using wago connectors (provided).
Connect black wire to live wire, white wire to neutral wire, and
green wire with ground (as shown) and secure using wago connector.
Close the cover of the box. (Figure 2)
CONNECT GROUND WIRE
USING WAGO CONNECTOR
ACCESS
NEUTRAL WIRE
(FROM POWER SUPPLY)
GROUND WIRE
(FROM POWER SUPPLY)
LIVE WIRE
(FROM POWER SUPPLY)
Figure 2 / Figura 2 / Schéma 2
3. Pull the spring clip on the fi xture up and through
the ceiling hole and place module in the hole mak-
ing sure the spring clips are holding securely. (Figure 3)
THROUGH
Figure 3 / Figura 3 / Schéma 3
STEP-BY-STEP GUIDE
(FROM DRIVER BOX)
GROUND
WIRE
NEUTRAL
(BARE COPPER /
WIRE
GREEN)
(WHITE)
(FROM POWER SUPPLY)
wago
NEUTRAL WIRE
connector
wago
GROUND WIRE
connector
LIVE WIRE
CEILING
HOLE
PULL UP
4. Turn the power back on. If the module doesn't illuminate
within 5 seconds, turn power off, carefully remove the module and
double check all wiring and replace. (Figure 4)
Figure 4 / Figura 4 / Schéma 4
WARNING:
DO NOT PLACE YOUR HAND UNDERNEATH SPRING CLIP
DURING REMOVAL PROCESS. SNAPPING OF THE CLIPS CAN
CAUSE INJURIES TO THE HAND. (Figure 5)
DO NOT
DO NOT
PLACE YOUR
PLACE YOUR
HAND
HAND
Figure 5 / Figura 5 / Schéma 5
DO NOT USE ANY OTHER DRIVER EXCEPT JUNO LIGHT-
ING DRIVER THAT IS INCLUDED WITH THE FIXTURE.
DO NOT CONNECT MULTIPLE MODULES TO ONE DRIV-
ER.
DO NOT OPEN THE MODULE AND SIDE PLATE OF THE
DRIVER BOX - NO SERVICEABLE PARTS INSIDE.
LIVE
WIRE
(BLACK)
wago
connector
Trouble Shooting Guide
If this fi xture fails to operate properly, use the guide
below to diagnose and correct the problem.
Verify that fi xture is wired properly.
Verify that fi xture is grounded correctly.
Verify that the line voltage at the fi xture is correct.
If further assistance is required, contact:
Technical Support at: (888) 387-2212
This LED module does not require service or new bulbs to
change.
Page 3
DO NOT
DO NOT
PLACE YOUR
PLACE YOUR
HAND
HAND
Publicité
