Zephyr PRW24F02BG Guide D'utilisation, D'entretien Et D'installation page 7

Safety Information
Before Using Your Appliance
Remove all exterior and interior packing.
⚫
Before connecting the appliance to the power source, let it stand upright for
⚫
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system caused by handling during transportation.
Clean the interior surface with warm water using a soft cloth.
⚫
The door on this appliance can be opened from either the left or the right side.
⚫
The unit is delivered with the door opening on the left side. Should you wish to
open the door from the right, follow the instructions, "Reversing the Door Swing of
your Appliance," listed below.
Installation of Your Appliance
The appliances are designed for either built-in, or free-standing installation.
⚫
WARNING: Do not store or install the appliance outdoors.
⚫
Place your appliance on a floor that is strong enough to support it when it is fully
⚫
loaded. To level your appliance, adjust the 4 legs until level.
Locate the appliance away from direct sunlight and sources of heat (stove, heater,
⚫
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly.
Never place the unit in damp areas.
⚫
Plug the appliance into an exclusive, easily accessible electrical socket.
⚫
Any questions concerning power and/or electrical connection should be directed
⚫
towards a qualified electrician or an authorized products service center.
The air vent at the front of the appliance must never be covered or blocked in any
⚫
way.
The appliance must be installed to all electrical connections in accordance with
⚫
state and local codes.
Use two or more people to move and install the beverage cooler. Failure to do so
⚫
can result in back or other injury.
The cooler may experience decreased cooling efficiency if air flow is restricted
⚫
due to a fully loaded cabinet.
7