Publicité
we
mo
FCC Compliance Statement
We, Belkin International, Inc., of 12045 E. Waterfront Drive, Playa Vista, CA 90094, declare under
our sole responsibility that the product, WSC010, to which this declaration relates, complies with
Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)
this device
may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if
not installed and used
in accordance with the
instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the distance between the equipment and the receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
Radiation
Exposure
Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Innovation,
Science and Economic Development (ISED)
Canada
Compliance Statement
CAN ICES-003 (B)/NMB-003 (B)
This device complies with ISED's license-exempt RSS standards. Operation is subject to the
following two conditions: (1) This device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
The device could automatically discontinue transmission in case of absence of information to
transmit, or operational failure. Note that this is not intended to prohibit transmission of control or
signaling information or the use of repetitive codes where required by the technology.
This device and its antennas(s) must not be co-located or operating in conjunction with any other
antenna or transmitter except in accordance with ISED multi-transmitter product procedures.
Publicité
