Publicité
This device has been designed to operate with an antenna having a maximum gain of -2 dBi at
2.4
GHz.
Antenna having a higher gain is strictly prohibited per regulations of ISED. The required
antenna impedance is 50
ohms.
The maximum antenna gain to comply with the EIRP limit is provided in the table
below.
Antenna No.
Antenna Type
Antenna Gain (dBi)
Antenna Connector
BT
IFA
-2
N/A
Radiation
Exposure
Statement:
This equipment complies with RSS-102 radiation exposure limits set forth for an uncontrolled
environment.
Safety
Caution:
When using this
product,
basic precautions should always be
followed, including,
but not limited
to,
the
following:
•
Unplug device prior to cleaning. Use dry cloth on exterior of the
device.
To avoid shock hazard
and/or damage to
device,
DO NOT use any liquid solution.
•
Do not use this product near the water, for example, in a wet basement or near a swimming pool.
•
Keep this product away from heat
sources,
direct sunlight, combustible gas,
humidity, water,
or
other
liquids.
•
Do not use this product if visible defects are observed or if it has been wet or damaged or
modified. Contact the customer service support of Belkin for assistance.
•
Do not
disassemble,
open, microwave, incinerate,
paint,
or insert foreign objects into this product.
•
Do not expose this product to fire or high temperature. Exposure to fire or high temperature may
cause explosion.
•
Do not expose this product to mechanical shock such as crushing, bending, puncturing, or
shredding. Avoid dropping or placing heavy objects on this product.
•
Please read the operating instructions and information on the minimum and maximum operating
temperatures supplied with this product.
•
To reduce the risk of
injury,
close supervision is necessary when this product is used near or by children.
•
This product is intended for indoor use
only.
•
Use of this product in a manner not recommended in these instructions may result in a risk of
injury to
persons.
For
support,
please visit: http://www.wemo.com/support.html
Declaration de conformite FCC
Nous, Belkin International, Inc., sis au 12045 E. Waterfront Drive, Playa Vista, CA 90094, declarons
sous notre seule responsabilite que le produit WSC010, auquel se refere la presente
declaration,
est conforme aux normes enoncees
a
l'alinea 15 de la reglementation FCC. Le fonctionnement est
assujetti aux deux conditions suivantes : (1) ce dispositif ne peut pas provoquer d'interference
nuisible, et (2) ce dispositif doit accepter toute interference
rec;ue,
y compris des interferences
pouvant entrainer un fonctionnement non desire.
Publicité
