Publicité
Les langues disponibles
Les langues disponibles
4. Mix Out
To allow operation of multiple YX15PC enclosures from a single source, the Mix Out line output is
provided. It should be connected to the Line In of the next YX15PC in the chain. The Line In level
control on the subsequent unit in the chain should be set to 0 dB in order to provide the same
output level as the master enclosure. When connecting multiple YX15PC enclosures, the last YX15PC
in the chain should be powered off first (and powered on last). Each YX15PC should be powered on
or off before the previous YX15PC in the chain. This will eliminate unwanted on/off noises.
5. Mic Gain Control
The microphone level control adjusts the mic level of the loudspeaker. It also adjusts the mic level on
all YX15PC enclosures in the chain (if multiple YX15PC enclosures are used).
6. Treble and Bass Controls
These controls affect all the sound coming out of a particular YX15PC enclosure. These controls do not
affect the sound at the Mix Out. In a system with multiple cabinets it will be necessary to adjust the
Bass, Treble, Mid and Bass controls on all individual enclosures.
7. Limit and Clip LEDs
These LEDs illuminate yellow when signal is limiting and red when the signal is too large for
the input and is clipping.
+24 PHANTOM
3
1
2
MIC IN
3
1
2
LINE IN
3
2
1
LINK OUT
LINE IN LEVEL
POWER LIMIT
CLIP
0
0
0
-
+
-
Min
Max
BASS
TREBLE
LINE IN
LINK OUT
MIC
GAIN
TONE CONTROLS
Bass Treble
LEVEL
YX SERIES
MIC LEVEL
0
+
Min
Max
MIC
5kHz
50 WATTS
30hz/5kHz
250 WATTS
3
Publicité
