Aurlane CAB274 Instructions D'installation page 13

Les langues disponibles

AURLANE products are guaranteed for 2 years, spare parts only. As the labor is not carried out by us, no labor

guarantee will be applied by AURLANE. In the event of a proven manufacturing defect or breakage of an element

of the cabin, these elements can be ordered from the distributor who sold this cabin, however in no case will the

labor relating to the replacement of the part be taken into account charge by AURLANE.

The installation of this shower enclosure needs to be carried out according to the rules of the art. Our company

declines all responsibility and reserves the right not to ensure its guarantee in the event that this product is not

installed by qualified personnel. In the event of a request for an item under warranty, it is imperative to provide

the purchase invoice for the product.

The glazed elements are wrapped in transparent film to allow the condition of these elements to be checked

during purchase. No replacement of these elements will be supported by AURLANE in the event that a breakage

is reported after the removal of the packages in store or during delivery the breakage of the glass is not covered

by guarantee if it is not clearly indicated on the delivery note.

It is essential to check the condition of each item when unpacking. No complaint relating to the quality of the

product will be taken into account after a period of 14 days after the purchase of the product. Remember to keep

the manual as well as an official purchase document (invoice, receipt) for any complaint or request for spare

parts.

Non-application of the guarantee: incorrect assembly, unsuitable hot water production, lack of maintenance,

limestone, accident or impact, use of abrasive or corrosive products, modification of the coating of the original

surface. Electrical and sanitary installation of the home not complying with regulatory standards.

Failure to follow instructions for use and installation methods will void the warranty.

The assembly must be carried out with at least two people, so as to be able to maintain and fix certain elements.

It is imperative not to embed the cabin in the wall and the floor. The back of a shower cabin must always remain

accessible in the event of the need to work on the connections. Also follow the pre-installation instructions on the

next page.

The glass elements are made of tempered glass for standards and safety reasons. As tempered glass is designed

to explode into (non-sharp) pieces on impact, these items should be handled with extreme care. For this same

reason, it is essential not to force the tightening of the accessories to be fixed on the glazed elements (door

handles, shelves, shower holder, towel holder, etc.). You can protect the glass elements by laying them on blankets

or pieces of carpet. Never place a glass part on an angle.

The pressure of the water supplied must be between 2 and 4 bars. Exceeding these limits influences the normal

use of the product. If the water pressure is very low, it is advisable to install a pressure pump, contact your

sanitary equipment distributor for this. If the pressure is too high, the cab piping may leak.

In order to facilitate the final assembly of the cabin, certain components such as nozzles or valves can be pre-

assembled on the product. However, it is imperative to check the tightening of the elements and to carry out a

water test before the final installation of the cabin.

GARANTEE

INSTALLATION