Publicité
Les langues disponibles
Les langues disponibles
• Do not touch the plug or any part of the vacuum with wet hands.
• A hazard may occur if the appliance runs over the supply cord.
• The plug must be removed from the socket-outlet before cleaning or maintaining the appliance.
• If the power cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.
• Neither use the vacuum to pick up flammable or explosive liquids such as gasoline, nor other liquids such as water or toxic liquids like bleach, ammonia, and drain cleaners.
• To avoid potential danger, do not run the vacuum on the power cords when using it.
• To reduce the risk of fire, explosion, or personal injury, check before use to make sure the lithium battery and power cord are undamaged. Do not use the vacuum if either
the lithium battery or power cord is damaged.
• The main body and the floor brush of the vacuum are electrically conductive and should not be immersed in water or other liquids.
• Clean the dirty water tank in time to avoid the decrease of suction and overheating of the motor caused by obstruction. Otherwise, the service life of the vacuum may be
affected. Do not use the vacuum if the roller brushbar, the dirty water tank, and the filter are not installed in place.
• Do not lift the vacuum when adding water to it at the base station.
• Make sure to turn off the vacuum before replacing the roller brushbar.
• Do not use the vacuum to clean up toner used in laser printers and copiers, as toner may cause fire or explosion.
• Do not use the vacuum to pick up smoking or burning materials such as charcoal, cigarette butts, or matches.
• Do not use the vacuum to pick up sharp or hard objects, such as glass, nails, screws, or coins, which may damage the vacuum.
• Do not use the vacuum to clean stains of thick oily substances, strong adhesives, or dyes, such as shoe polish, paints, and pigments.
• Keep hair, loose clothing, fingers, and other parts of the body away from the vacuum's openings and moving parts.
• Do not put any object into the vacuum's openings, nor use the vacuum with any opening blocked. Keep free of dust, lint, hair, or other items which may reduce airflow.
• Do not shake the vacuum up and down or hit it violently to prevent dirty water from flowing into the motor.
• Do not lift or move the vacuum while the motor is operating, nor tilt it to one side or lay it flat to prevent dirty water from entering the motor.
• Do not place the vacuum on unstable surfaces such as chairs or tables to prevent damage or personal injury caused by its falling off. If the vacuum malfunctions because
of being knocked over or damaged, please contact the authorized service department. Never attempt to disassemble the vacuum on your own.
• Do not block the drying air outlet on the base station to avoid malfunctions.
• After washing the cleaning tray and the accessory container clean, thoroughly dry them before reinstalling them to the base station.
• After cleaning the roller brushbar, the filter, and the cleaning brush, thoroughly dry them before putting them into the accessory container to prevent odors.
• Do not rinse the base station with water.
• Use clean tap water when adding water to the water tank of the base station.
• Do not charge or store the vacuum near heat sources or in humid areas, such as by a radiator or in a kitchen or bathroom.
• Only use replacement parts that are approved by OSOTEK.
• Do not repair the vacuum on your own when it breaks down or has problems like electric leakage, overheating motor, making unusual sounds, overheating main body, giving
off bad odors, or weak suction.
• Do not use any third-party battery or power cord. The vacuum can only be used with the model A020H100CS/A020H100CS.1base station.
• Fire Hazard Warning: Do not apply any type of fragrance to the vacuum's filter. These types of products are known to contain flammable chemicals which may cause the
vacuum to catch fire.
• The base station can only be used to dry the roller brushbar, the filter, and the cleaning brush of this vacuum.
• Do not use any third-party battery or power cord. Only use the A020H100CS/A020H100CS.1 base station provided with the appliance.
• Do not use the appliance at ambient temperature above104°F(40°C) or below41°F (5°C).
2
Publicité
