Feiss Rolland Instructions D'installation

Installation Instructions for
Rolland Outdoor Wall
Outdoor
G ENERAL RODUCT NFORMATION P
These fixtures are intended to be installed utilizing
junction boxes.
This product is safety listed for wet locations.
For a complete list of dimmers, visit out website at
1A
JUNCTION BOX
LED ASSEMBLY SCREW
ANCHOR
13
Insert the glass panels into the shade, then secure them by installing the brackets using the screws and washers.
1
Install the LED assembly to the top fixture using the LED assembly screws.
2
Install the cover to the top of the fixture using the cover screws.
3
Temporarily install the mounting plate to the junction box.
4
Mark the anchor hole locations on the mounting plate and remove the mounting plate.
5
Drill appropriate size holes at the marked locations and install the anchors.
6
Secure the mounting plate to the junction box.
7
Screw the anchor screws into the anchors.
8
9 Connect the fixture to a suitable ground in accordance with local electrical codes.
10 Connect the white fixture wire to the neutral power line wire with a wire nut.
11 Connect the black fixture wire to the hot power line wire with a wire nut.
12 Mount the fixture base onto the mounting plate and secure it with the fixture screws.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
13
I :
NEC compliant
www.Feiss.com
LED ASSEMBLY
MOUNTING
PLATE
ANCHOR
SCREW
12
FIXTURE
SCREW
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1
2
3
COVER
SCREW
1
OL14200-OL14201-LED
OL14200, OL14201-LED
CAUTION RISK OF FIRE -
COVER
SCREW AND WASHER
BRACKET
GLASS PANEL
FIXTURE
1.0