Feiss Ellerbee OL11500 Guide Rapide

Installation Instructions for
Ellerbee Outdoor Wall (LED)
Wall
G ENERAL RODUCT NFORMATION P
These fixtures are intended to be installed utilizing
junction boxes.
This product is safety listed for wet locations.
For a complete list of dimmers, visit out website at
1A
JUNCTION BOX
GLASS PANEL SCREW
GLASS PANEL WASHER
MOUNTING
GLASS PANEL
PLATE
ANCHOR
5
5
3
3
3
3
5
5
1 For Models OL11502, OL11503 Only: Temporarily install the mounting plate to the junction box.
2 For Models OL11502, OL11503 Only: Mark the anchor hole locations on the mounting plate and remove the mounting plate.
For Models OL11502, OL11503 Only: Drill appropriate size holes at the marked locations and install the anchors.
3
Secure the mounting plate to the junction box.
4
For Models OL11502, OL11503 Only: Screw the anchor screws into the anchors.
5
Connect the fixture to a suitable ground in accordance with local electrical codes.
6
Connect the white driver wire to the neutral power line wire with a wire nut.
7
8 Connect the black driver wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
9
10 Insert the glass panels into the housing and secure them using the glass panel washers and screws.
11 Insert the diffuser into the
using the diffuser cover screws.
Secure the housing to the fixture using the housing screws.
12
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
13
I :
NEC compliant
www.Feiss.com
MOUNTING PLATE
7
6
8
FIXTURE
SCREW
10
ANCHOR
SCREW
DIFFUSER BASE
diffuser base, place the diffuser cover on top of the
CAUTION RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
9
DIFFUSER
9
11
HOUSING SCREW
12
diffuser
1
OL11500_OL11501_OL11502_OL11503-LED
O 11500,O 11501, L L
O 11502, O 11503-LED L L
-
FIXTURE
13
DIFFUSER COVER SCREW
DIFFUSER COVER
HOUSING
, and secure it to the top of the housing
1.0