KRATOS SAFETY VORAS FA 20 301 02 Mode D'emploi page 8

Chemical products: put the system out of use if it is exposed to chemical products, solvents or fuels which could affect its working.
TECHNICAL DATA: Webbing: 50 mm – Material: polyamide – breaking point > 15 KN
SUITABILITY FOR USE:
The equipment should be used with a fall arrest system as specified in the data sheet (see standard EN363) to guarantee that the dynamic force exerted
on the user during the arrest of a fall is maxi 6 kN. A fall arrest harness (EN361) is the only body gripping device that may be used. It may be dangerous
to create one's own fall arrest system where each safety function can interfere with another safety function. Therefore, it is important to read the
recommendations on using each component in the system before use.
VERIFICATION:
The recommended service life of the equipment is 10 years (in accordance with the annual examination by a competent person authorized by KRATOS
SAFETY), but it may be increased or reduced according to use and/or the results of the annual inspections. The equipment should be inspected if there is
any doubt, or following a fall and at least annually, by the manufacturer or a competent person authorised by the manufacturer to check its strength and
hence the user's safety. The product's factsheet must be completed (in writing) after each check, the inspection date and the date of the next inspection
must be indicated on the factsheet, it is also advisable to specify the date of the next inspection on the product.
SERVICING AND STORAGE; (Comply strictly with these instructions)
During transport, keep the product in its packaging, well away from any cutting surface; clean it with water, wipe it with a rag and hang it up in a well-
ventilated location, to let it dry naturally and away from a naked flame or heat source; follow the same procedure for components that have become damp
during use. The system must be stored in its packaging in a dry, well aired place protected from extremes of temperature.
8