Teesa Hypercare T200 Manuel D'utilisation page 22

22
1. Make sure the comb lock switch is set to
position then attach the adjustable comb to
the appliance (see "Attaching and removing the
adjustable comb" section).
Note: It is also possible to use the appliance without
EN
the comb. In that case, all beards will be trimmed.
2. Slide the comb up and down to set the desired
cutting length.
3. Set the comb lock switch to
the setting.
4. Slide the Power switch upwards to turn on the
appliance.
5. Start trimming your beard.
6. When trimming is finished, turn off the appliance
by sliding the Power switch downwards.
7. If the appliance was used with the comb attached,
remove and clean the comb and the whole
appliance according to the instructions included in
"Cleaning" section.
General:
• Do not immerse the appliance in water.
• Do not clean the blade under running water. Clean
it only with the included brush.
OPERATION
CLEANING
Owner's manual
position to lock in