Amica EH 923 630 SM Notice D'utilisation page 76

INSTALLATION
Installing the oven
 The kitchen area should be dry and aired
and equipped with efficient ventillation.
When installing the oven, easy access to
all control elements should be ensured.
 This is a Y–type design built–in oven,
which means that its back wall and one
side wall can be placed next to a high
piece of furniture or a wall. Coating or
veneer used on fitted furniture must be
applied with a heat–resistant adhesive
(100°C). This prevents surface deforma-
tion or detachment of the coating.
 Hoods should be installed according to
the manufacturer's instructions.
Assembly of the oven:
 Make an opening with the dimensions
given in the diagram for the oven to be
fitted.(Fig.A)
 Make sure the mains plug is disconnected
and then connect the oven to the mains
supply.
 Partially insert the oven into the prepared
opening and connect the oven to the hob.
(Fig.B)
 The appliance must be earthed. Connect
the earth lead of the hob (yellow–green)
with the earth terminal of the oven (mar-
ked ) which is located near the connec-
tion box
 Insert the oven completely into the ope-
ning without allowing the four screws in
the places shown in the diagram to fall
out. (Fig.C)
Fig. A
Fig. B
76