Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DOUBLE INSULATION
Double insulation is a concept in safety in electric products,
which eliminates the need for the usual three-wire grounded
power cord. All exposed metal parts are isolated from the
internal metal motor components with protecting insulation.
Double insulated products do not need to be grounded.
WARNING:
The double insulated system is intended to protect the
user from shock resulting from a break in the product's
internal wiring. Observe all normal safety precautions to
avoid electrical shock.
NOTE: Servicing of a product with double insulation requires
extreme care and knowledge of the system and should
be performed only by a qualified service technician. For
service, we suggest you return the product to your nearest
authorized service center for repair. Always use original
factory replacement parts when servicing.
ELECTRICAL CONNECTION
This is a hybrid product capable of operating on alternating
current (AC) through an extension cord or direct current (DC)
through a battery pack. If the product does not operate when
an extension cord or battery pack is installed, double-check
the power supply.
To use alternating current, connect the product to a power
supply that is 120 volts, AC only (normal household
current), 60 Hz.
Ground Fault Circuit Interrupter (GFCI) protection
should be provided on the AC circuit(s) or outlet(s) to
be used for the fan. Outlets are available having built-in
GFCI protection and may be used for this measure of
safety.
If a protected AC outlet is not available, do not use
the fan until an outlet can be changed or auxiliary
protection can be obtained. These auxiliary protection
devices are available at your local retailer.
ELECTRICAL
To use direct current, install a manufacturer-
recommended 18 volt battery pack only.
NOTE: Do not operate this product on direct current
through an extension cord. Doing so would cause a
substantial voltage drop, which will cause a loss of power
and could cause the product to overheat.
EXTENSION CORDS
When using a product at a considerable distance from a
power source, be sure to use an extension cord that has
the capacity to handle the current the product will draw. An
undersized cord will cause a drop in line voltage, resulting in
overheating and loss of power. Use the chart to determine
the minimum wire size required in an extension cord. Only
round jacketed cords listed by Underwriter's Laboratories
(UL) should be used.
Before using any extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
Conductor Size
Wire Size
(A.W.G.)
18
17
16
14
12
**Used on 12 gauge - 20 amp circuit
NOTE: AWG = American Wire Gauge
WARNING:
Keep the extension cord clear of the working area.
Position the cord so that it will not get caught on lumber,
tools, or other obstructions while you are working with
this product. Failure to do so can result in serious
personal injury.
WARNING:
Check extension cords before each use. If damaged
replace immediately. Never use a product with a damaged
cord since touching the damaged area could cause
electrical shock resulting in serious injury.
4 – English
Ampacity (Amperes)
Ampere rating (on product data plate)
50 ft. or less
(mm
)
2
in length
(-0.82)
10
(-1.04)
12
(-1.31)
13
(-2.08)
18
(-3.31)
25
Over 50 ft.
in length
7
10
12
13
18
Publicité
Table des Matières
