Publicité
Les langues disponibles
Les langues disponibles
•
If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM bat-
tery pack replacement available from
our Customer Service.
•
Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").
Assembling instructions
Turn off the appliance and, before
doing any servicing, remove the
battery.
If the equipment pipes are not
plugged together and screwed
correctly then the equipment
cannot be switched on.
Operation is prevented by a
safety switch!
Use only original parts.
Assembling the Equipment
1. Interlock the end of the hex-
agonal aluminium pipe of the
telescopic arm (6) and the end
of the arm below the cutting
head (2) up to the stop. Whilst
interlocking the two, ensure that
the nose (6a) of the hexagonal
aluminium pipe fits into the nut
(2a) at the end of the arm (see
small image).
2. Fasten both parts using the
screw sleeve (5)
Operation
Do not use the equipment without
the hand guard. Wear suitable
clothing and work gloves when
working with the equipment.
Ensure that the equipment is
functional before each use. The
On/Off switch and the safety
switch must not be held closed.
They must switch off the motor
when on is released. Should a
switch be damaged, stop work-
ing with the equipment.
Note noise protection and local
specifications.
Attaching the Shoulder Strap
1. Fix the spring clips on the
shoulder strap (15) to the carry-
ing eyelet (9) on the telescopic
handle of the equipment.
2. Adjust the strap length such
that the carrying eyelet (9) is at
hip height.
3. The height of the carrying eye-
let (9) can also be adjusted on
the telescopic handle after loos-
ening the Allen screw (9a).
Adjust telescopic arm
The telescopic arm (6) can be continu-
ously adjusted via the quick release fas-
tener (7).
1. Fold the lever (7) forward
.
according to the image and
change the length of the arm by
pushing and pulling it.
2. Fold the lever (7) back and set
the desired working length of
the telescopic arm (6).
GB
57
Publicité
