Publicité
Les langues disponibles
Les langues disponibles
English
1. To fix the tool holder on the machine,
introduce the shank and use the pin for
positioning. Tighten the 4 fixing screws
(important, make sure that the screws
have the same clamping force).
2.
Adjust the offsets of the 2 positions.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
KSE510-2x
3.
When mounting or dismounting of
cutting tools, spindle lock on the dishes
provided for this purpose, using an an
adapted wrench.
4.
The
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
MARK :
empty positions. Use the supplied
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
RBT
Validation : 27.01.2022
tool shank diameter should never
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
KSE510-2x 1-.
Mode
d'emploi.docx
Page : 2 de 4
Publicité
