Mx Onda MX-PB2440 Manuel D'instructions page 23

PREPARATION
To insert or replace the batteries, follow the steps below:
- Open the lid of the battery compartment located in the base.
- To remove the batteries, use a pointed object to slide the battery towards
the electrical contact (see figure 1), then pull it outwards. To place the
batteries (type CR2032) with the positive (+) terminal facing up, insert the
battery towards the electrical contact (see figure 2), then lightly press the
battery until it is retained by the plastic tabs.
- Replace the battery compartment cover.
Fig. 1
With the scale on, press the selector button of the weight unit located at the
base of the scale, each time you press this button you will change the unit
of weight Kg (kilograms) or Lb (pounds).
To avoid errors in the measurement of the ambient temperature, when you
move the scale from one room to another, you must wait a while for the
thermometer of the scale to measure the temperature of the new room.
HOW TO USE
Gently climb the scale (for maximum precision, do not move until the
screen shows a stable reading), the scale will automatically turn on and
start reading the weight.
After reading the weight, the screen will show the ambient temperature of
the room where the scale is located.
The scale will turn off automatically after a few seconds, thus prolonging
the life of the batteries.
When the weight limit of the scale is exceeded, the display will show the
EEEE
" " overload indication.
CLEANING AND MAINTENANCE
When the thermometer shows the digits "
temperature of the room is below -10 °C and if it shows the digits "
will indicate that the temperature of the room is above 50 °C.
When the display shows the digits "
indicate that the batteries are exhausted and need to be replaced.
Do not try to disassemble the batteries, do not short and never heat them
or throw them into the fire. Do not mix new batteries with used batteries.
Fig. 2
EL
" it will indicate that the
Lo
" when the scale is turned on, it will
3
EH
" it