Feiss Livingston 1 Instructions D'installation

Installation Instructions for
Livingston 1 Light Wall
Wall/Outdoor
G ENERAL RODUCT NFORMATION P
This product is listed by one of the following
" ationally ecognized esting aboratory" N R T
Model OL14002 is suitable for wet locations.
Model Wb1727 is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
1A
LAMP
SHADE
FRAME
1 Secure the mounting plate to the electrical box with the two mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
2
Connect the white fixture wire to the neutral power line wire with a wire nut.
3
Connect the black fixture wire to the hot power line wire with a wire nut.
4
Mount the fixture base onto the mounting plate and secure it with the Allen wrench.
5
6
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
7
Align and insert the shade into the fixture, then rotate it clockwise to lock it in place.
8
Install rubber caps onto the ends of the frame and insert the ends of the frame into the fixture.
9 For wet locations, caulk around the base with waterproof construction sealant.
I :
L
9
ALLEN
6
WRENCH
7
8
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
NEUTRAL WIRE
WHITE WIRE
5
HOT WIRE
BLACK WIRE
RUBBER CAPS
1
OL14002-W 1727
O 14002, W 1727_ L B
ELECTRICAL BOX
1
1
MOUNTING
PLATE
MOUNTING
PLATE SCREW
B
1.1