Technical Specifications - Fracarro SIG7120 Instructions D'emploi

Connector
Typology
Maxiumum bitrate
Level
TS flow
Programs
Selection by means of the TPE of the programs that should be remodulated
Regeneration of the DVB-T table
Multiplexing of the DVB-T
PCR restamping, LCN management
Connectors
Frequency range
Channels
Frequency step
Frequency precision
Maximum output level
Channel flatness
Level adjustment
Loop-through loss
Return Loss
Modulation type
Channel bandwidth
Carriers
Constellations
FEC
Guard interval
Spectrum
Output MER
Spurious level
Operational temperature
Back panel connection
Power supply tension
Maximum consumption
Technical data is nominal values and refer to an operating temperature of 5° C.

8. TECHNICAL SPECIFICATIONS

TRANSPORT STREAM INPUT
48 poles on the back panel or 75Ω BNC front
Parallel (8 data bits, clock e datavalid) o Serial (ASI
– only for SIG711)
100 Mbit/s (parallel, back-panel) o 70Mbit/s (se-
rial on BNC – only for SIG711)
TTL
Continuous mode or burst
SD o HD, FTA o CA, MPEG o H64
FILTERING AND MULTIPLEXING PID
OUTPUT SIGNAL
F TYPE, FEMALE
111 ÷ 86 MHz
S ÷ E69
10 KHz
< 5 KHz
85 ±  dBμV
< ±1dB
0 ÷ 15dB (programmable 1dB step)
< 1.5 dB
> 10 dB
DVB-T (ETSI EN 300 744)
6, 7, 8 MHz
K, 8K
QPSK, 16QAM, 64QAM
1/, /3, 3/4, 5/6, 7/8
1/4, 1/8, 1/16, 1/3
Normal, reverse
> 34 dB
≥ 50 dB
GENERAL
-10 ÷ 45ºC
0 VAC, RS485, ADDRESSES LINE, TS
184 ÷ 64VAC, 50÷60Hz, CLASS II
10 W
34