Publicité
Les langues disponibles
Les langues disponibles
It is very important to keep the belt
well
lubricated
maintenance and to avoid expensive
damages.
It is advisable to lubricate the base of
the belt between the board and the
band depending on how often it is
used.
<6
>6
Note:
This
preventive
schedule is only meant for home use.
It is suggested to maintain the unit every
month for commercial use.
In aggressive environments, with high
dispersion of particles or with heavy
weight
people,
should be increased accordingly.
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6mm Allen
key and with the machine set to 4km/h
turn screws (R & L) one turn in a
clockwise direction.
8 ADJUSTING THE BELT.-
CAUTION:
Before
machine, turn it on and check that
the belt is centered. If necessary,
follow the steps below.
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways.
If the belt does shift to the left or right,
stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important. Follow
these steps. In order to adjust the belt,
set the unit in motion at a speed of
for
its
correct
Hours per week
<=7
>7
1 month
1 month
2 months
1 month
maintenance
lubrication
frequency
using
4km/h. If the belt has moved to the right,
turn screw (R) on the right-hand side of
the machine a 1⁄4 turn clockwise. Note
the position of the belt, if after one minute
the belt is not completely centred then
repeat the operation. If you see that the
belt has moved too far over to the left
then turn the right screw back slightly in
an anticlockwise direction. Fig.8.
As soon as you have adjusted the belt
you can begin exercising again.
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1⁄4 turn clockwise.
Note the position of the belt, if after one
minute the belt is not completely centred
then repeat the operation.
If you see that the belt has moved too
far over to the right then turn the left
screw back slightly in an anticlockwise
direction. Fig.8.
Important: Overtightening of the belt
can lead to a loss of speed on the
machine and even stretch the belt
itself. Bear In mind that one turn of the
right screw (R) in a clockwise direction
has the same effect on the position of
the belt as one turn of the left screw (L)
in
an
the
Consequently,
excessive belt movement you can use
either of the two screws in order to
avoid overtightening the belt.
FOLDING YOUR UNIT.-
This treadmill is equipped with a
folding
purposes. To use it, stop the treadmill,
lower the elevation level to minimum,
unplug the mains cable and lift the unit
until you hear lever (65) click into
place, Fig.5. Store your unit in a dry
18
anticlockwise
in
the
mechanism
for
direction.
event
of
storage
Publicité
