Midea MLC31N5AWW Mode D'emploi page 22

In a floor drain system
NOTE:
•
A floor drain system requires a siphon break (not included). The siphon
break must be a minimum of 28 in. (71 cm) from the bottom of the
washer.
•
If the drain hose on the washer is shorter than the siphon break
distance, attach an extra drain hose (not included) to the washer's
drain hose.
Place the drain hose into the floor drain system. The weight of the hose and
gravity keep the drain hose in the drain.
Level your washer
Caution
Don't use your washer without leveling it. If your washer isn't level, it may:
•
Vibrate excessively which can cause your washer to malfunction
•
Make excessive noise
Extend the leveling feet only as much as is necessary. If the feet are
extended too much, your washer may vibrate.
1.
Make sure that the legs are flush with the washer cabinet. If needed,
use a wrench to loosen the lock nut on a leg, slide the leg up, then
tighten the bolt.
22
28 in. (71 cm) min.