Luna MB150-1 Notice D'utilisation page 15

ENGLISH
INNEHÅLLSFÖRTECKNING
Technical data ..........................................................14
Installation ................................................................14
Operating the grinder ...............................................14
Before starting the motor check that ........................14
Wheel care ...............................................................15
TECHNICAL DATA
Art.no. .............................................. 20727
Luna ........................................................Nr
Supplied with grinding disc ................. mm
Spindel speed ....................................... rpm
Distance between grinding wheels ....... mm
Height to centre of spindle ................... mm
Abrasive belt dimension ...................... mm
Motor voltage ...........................................V
.....................................................................
Motor output ............................................W
Rated current ............................................A
Weight .....................................................kg
INSTALLATION
The voltage supply to which the machine is to be con-
nected must be within the range shown on the mach-
ine nameplate. If a fused plug is used the fuse rating
should be approximately twice the full load rating of
the machine.
The connection must only be done by an authorized
electrician. Remember to check that the machine is
running against the tool rest before start operating the
machine.
Secure the machine firmly to a work bench or pede-
stal. The pedestal used must be fixed to a firm level
surface.
Abrasive wheels must be checked to make sure that
the manufacturer's maximum permissible safe ope-
rating speed shown on label exceeds the maximum
machine speed as shown on the nameplate.
General .....................................................................15
2 years guarantee ......................................................15
Wiring diagram ........................................................28
Parts diagram + Parts list .........................................29
EU Declaration conformity ......................................30
-0109 -0208
MB150-1 MB200-1
150x20x32 200x25x32
2800-3300 2800-3300
282
140
-
230 1-phase 230 1-phase
50-60 Hz 50-60 Hz
500
1.7
15
Operating the grinder
Before starting the motor check that:
End shields are secured to the main wheel guard by
screws, which must bc secured at all times.
Wheel can be revolved freely by hand.
The toolrests are in position, adjusted to within 3 mm
(1/8") of the periphery face of the wheel, and firmly
secured.
The protective eyeshields fitted to Bench Grinders
are clean and secured in the correct position, or that
recommended and approved type of pretective gogg-
les, with clean lenses, are worn before operating the
machine.
14
-0307
MB200B-1
200x25x32
2800-3300
315 -
140 -
- 50x800
230 1-phase
50-60 Hz
650 650
1.3 1.3
16
18