Johnson JWAS14BINT Guide D'utilisation page 72

Step 3. Dishwasher installation steps
Please refer to the specified installation steps
in the installation drawings.
1. Affix the condensation strip under the work surface of cabinet.
Please ensure the condensation strip is flush with edge of work
surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position. (Step 4)
6. Level the dishwasher. The rear foot can be adjusted from the
front of the dishwasher by turning the Philips screw in the
middle of the base of dishwasher use an Philips screw. To adjust
the front feet, use a flat screw driver and turn the front feet until
the dishwasher is level. (Step 5 to Step 6)
7. Install the furniture door to the outer door of the dishwasher.
(Step 7 to Step 9)
8. The dishwasher must be secured in place. There are two ways to
do this:
A. Normal work surface: Put the installation hook into the slot
of the side plane and secure it to the work surface with the
wood screws.
B. Marble or granite work top: Fix the side with Screw.
A
B
23
V.1