Samsung UE-65LS003 Manuel De L'utilisateur page 7

02 Connecting the TV to the One Connect
Refer to the following figure and connect the Invisible Connection, supplied as an accessory, between the TV and the
One Connect. Be sure to first untie the cable ( ) of the Invisible Connection that is connected to the TV. If you untie
the cable ( ) of the Invisible Connection that will be connected to the One Connect, the cable may be entangled or
damaged.
1. Connect the connector ( ) of the Invisible Connection to the TV, and then connect the connector ( ) to the One
Connect.
2. After connecting the Invisible Connection between the TV and the One Connect, connect their power plugs to
power outlets.
• When connecting the Invisible Connection, use a Bending Cover to prevent the cable of the Invisible
Connection from being bent at a 90 degree angle. Failure to do so may cause damage to the cable.
• When connecting the Invisible Connection, pay attention to the shapes of its connectors so that they
are connected correctly. Failure to do so may cause product malfunction.
• After connecting the Invisible Connection, wind the remaining cable around the Invisible Connection
tube. Just winding or leaving the remaining cable as it is may cause damage to the cable.
• When connecting the Invisible Connection, be careful not to twist the cable of the Invisible Connection.
Failure to do so may cause performance degradation to the TV or damage to the cable.
• Be careful not to take the following actions to prevent the Invisible Connection from being damaged:
CLASS 1 LASER PRODUCT
• Caution - Invisible laser radiation when open. Do not stare into beam.
– Do not bend or cut cables excessively.
– Do not place heavy objects on the cable.
– Do not disassemble the connector of the cable.
herein may result in hazardous radiation exposure.
Bending
• Caution - Use of controls or adjustments or performance of procedures other than those specified
Twisting
ONE CONNECT
Bending Cover
Pulling Stepping on
English - 7
Pressing on
One connect