Publicité
Les langues disponibles
Les langues disponibles
English
4. While depressing the spindle lock button, thread the
threaded locking flange
4
nOTE: If the wheel you are installing is more than 1/8"
(3.17 mm) thick, place the threaded clamp nut on the
spindle so that the raised section (pilot) fits into the
center of the wheel. If the wheel you are installing is
1/8" (3.17 mm) thick or less, place the threaded clamp
nut on the spindle so that the raised section (pilot) is not
against the wheel.
Fig. E
Over 1/8" (3.17 mm)
wheels
Locking flange
Backing Flange
5. To remove the wheel, depress the spindle lock button
and loosen the threaded locking flange.
Fig. F 14
4
13
3
1
Mounting Sanding Backing Pads (Fig. G)
nOTE: Use of a guard with sanding discs that use backing
pads, often called fiber resin discs, is not required. Since a
guard is not required for these accessories, the guard may or
may not fit correctly if used.
WARNING: Failure to properly seat the clamp nut
and/or pad could result in serious injury (or damage
to the tool or wheel).
WARNING: Proper guard must be reinstalled for
grinding wheel, cutting wheel, sanding flap disc,
wire brush or wire wheel applications after sanding
applications are complete.
1. Place or appropriately thread backing pad
the spindle.
2. Place the sanding disc
16
3. While depressing spindle lock button
sanding clamp nut
on spindle, piloting the raised
17
hub on the clamp nut into the center of san ding disc
and backing pad.
8
on spindle.
1/8" Or less (3.17 mm)
wheels
Locking flange
Backing Flange
15
on
on the backing pad
.
15
, thread the
2
4. Tighten the clamp nut by hand. Then depress the
spindle lock button while turning the sanding disc until
the sanding disc and clamp nut are snug.
5. To remove the wheel, grasp and turn the backing
pad and sanding pad while depressing the spindle
lock button.
Fig. G
17
16
15
Mounting and Removing Hubbed
Wheels (Fig. A)
Hubbed wheels install directly on the spindle. Thread of
accessory must match thread of spindle.
1. Remove backing flange by pulling away from tool.
2. Thread the wheel on the spindle
3. Depress the spindle lock button
tighten the hub of the wheel.
4. Reverse the above procedure to remove the wheel.
NOTICE: Failure to properly seat the wheel before
turning the tool on may result in damage to the tool
or the wheel.
Mounting Wire Cup Brushes and
Wire Wheels (Fig. A)
WARNING: Failure to properly seat the brush/wheel
could result in serious injury (or damage to the tool
or wheel).
CAUTION: To reduce the risk of personal injury,
wear work gloves when handling wire brushes
and wheels. They can become sharp.
CAUTION: To reduce the risk of damage to the
tool, wheel or brush must not touch guard when
mounted or while in use. Undetectable damage
could occur to the accessory, causing wires to
fragment from accessory wheel or cup.
Wire cup brushes or wire wheels install directly on the
threaded spindle without the use of flanges. Use only wire
brushes or wheels provided with a threaded hub. These
accessories are available at extra cost from your local dealer
or authorised service center.
1. Place the tool on a table, guard up.
2. Thread the wheel on the spindle by hand.
3. Depress spindle lock button
hub of the wire wheel or brush to tighten the wheel.
1
by hand.
2
and use a wrench to
2
and use a wrench on the
Publicité
